Disassembly instructions 10 – MITSUBISHI ELECTRIC Mitsubishi Split-Type User Manual
Page 24
24
DISASSEMBLY INSTRUCTIONS
10
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector has the
locking mechanism.
1
Slide the sleeve.
2
Pull the terminal while
pushing the locking
lever.
1
Hold the sleeve, and
pull out the terminal
slowly.
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<"Terminal with locking mechanism" Detaching points>
Connector
Sleeve
Locking lever
MSZ-GA22VA -
MSZ-GA25VA -
MSZ-GA35VA -
INDOOR UNIT
E1
E1
E1
OPERATING PROCEDURE
PHOTOS
Photo 1
1. Removing the panel
(1) Remove the horizontal vane.
(2) Remove the screw caps of the panel.
Remove the screws. (See Photo 1.)
(3) Hold the lower part of both ends on the panel and pull it
slightly toward you, and then remove the panel by pushing
it upward.
Screws of the panel
Horizontal vane
OB378_--1qxp 05.1.17 12:55 Page 24