beautypg.com

MITSUBISHI ELECTRIC Mitsubishi Split-Type User Manual

Page 19

background image

19

The unit does not operate with the remote controller.
Also, OPERATION INDICATOR lamp does not light up by pressing EMERGENCY OPERATION switch.

Check of indoor electronic control P.C. board and indoor fan motor

C

Yes

No

w

1. The fan motor connector's

1

lead wire is red, whereas

3

is black.

w

2. Connect "+" of the tester to fan motor connector's

1

lead

wire, and "-" to

3

lead wire, otherwise the resistance cannot be

measured properly.

w

3

w

3. Short circuit:

The indoor fan motor is
abnormal.

Yes

No

w

1,2

Does the unit operate with the remote controller?
Does OPERATION INDICATOR lamp light up by
pressing EMERGENCY OPERATION switch?

Turn OFF the power supply.
Remove indoor fan motor connector CN211 and
vane motor connector CN151 from the indoor electronic
control P.C. board and turn ON the power supply.

Measure the resistance of the horizontal vane
motor coil.
Normal value is approx. 300

'

to 250

'

.

Measure the resistance between CN211

3

and

4

of the indoor fan motor connector.

Normal value is approx. 30k

'

to 50k

'

.

Short circuit:
Replace the indoor fan motor.

Short circuit:
Replace the horizontal vane motor and the indoor
electronic control P.C. board.

Turn OFF the power supply.
Check both “parts side” and “pattern
side” of the indoor electronic control P.C.
board visually.

Replace the varistor(NR11) and fuse(F11).

Are the varistor(NR11) burnt
and the fuse(F11) blown?

Be sure to check both the fuse
and the varistor in any case.

No

Yes

No

Is the fuse(F11) blown only?

Yes

No

Is the resistance 1M

'

or more?

Measure the resistance between

1

(+) and

3

(-) of the indoor fan

motor connector (to CN211 on the
indoor electronic control P.C. board) .

Replace the fuse (F11).

Replace the fuse (F11) and the indoor fan motor.

Is the resistance
approx. 4

'

?

Measure the cement resistance R111 on
the indoor electronic control P.C. board.

Replace the indoor electronic control P.C. board.

Replace the indoor electronic control P.C. board
and the indoor fan motor.

Yes

CN211

Fuse(F11)

Varistor(NR11)

Indoor electronic
control P.C.Board

OB378_--1qxp 05.1.17 12:55 Page 19

This manual is related to the following products: