Philips Magnavox CCZ130AT - Manual (Page 41)

1
Press the COMBI button, then press the VCR
PLUS+/ENTER button.
VCR PLUS+ PROGRAM
PLUS CODE : – – – – – – – –
TO END PRESS EXIT
Timer Recording With the VCR Plus+ Programming System 41
Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
● The clock has been set. If not, CLOCK MUST BE SET appears.
● Channels are programmed.
● There is a tape in the TV/VCR (make sure the tape’s record tab
is intact and the tape is long enough to record the program).
● You have completed the steps on pages 39-40.
Complete each step within 60 seconds of completing the
previous step. If you don’t, you may return to step 1.
2
Press the Number buttons to enter the PlusCode pro-
gramming number of the program you wish to record (this
number is different for every program, and it can be three to eight
digits long). Finally, press the VCR PLUS+/ENTER button.
3
Press the PLAY/▲ button or the STOP/▼ button to select
a ONCE, DAILY, OR WEEKLY recording. Then, press the
F.FWD/B button.
● ONCE: The VCR will record a TV program on any day you
choose, up to 12 months away.
● DAILY: The VCR will record every day from Monday to Friday
– starting at the same time and recording for the same length of
time.
● WEEKLY: The VCR will record on the same day, at the same
time, and for the same length of time every week.
• If the power fails, programmed timer
recordings will not be lost. The pro-
grammed timer recordings will be
restored when the clock is reset after
the power failure. (The clock will
reset itself automatically if you are
using the AUTO CLOCK feature.
Details are on pages 14 - 17. If you
are not using the AUTO CLOCK fea-
ture, reset the clock manually; then,
the timer recordings will be restored.
Details are on pages 12 - 13.) The
timer recording will not occur only if
the timer recording was scheduled to
take place during the power failure.
• You cannot set a timer recording if
DEFEAT RECORDING is set to ON.
Details are on page 43.
• If CODE ERROR flashes after you
enter the PlusCode programming
number and press the VCR
PLUS+/ENTER button, the number
you entered was incorrect (for exam-
ple, too short). If this happens, enter
the correct number.
• CLASH may flash on the screen after
you complete step 2. This means
that the timer recording you just pro-
grammed and another timer record-
ing overlap, and thus the current
timer recording will not be carried
out.
Helpful Hints
VCR PLUS+ PROGRAM
> ONCE
DAILY (MON - FRI)
WEEKLY
SELECT ▲▼ CHOOSE B
TO END PRESS EXIT
VCR PLUS+ PROGRAM
PLUS CODE : 95557 – – –
TO SET PRESS VCR +
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
1
2
3
VAR.SLOW
CABLE/DBS COMBI
VOL.
CH.
A.CH +100
3
6
9
0
2
5
8
1
4
7
TRACKING F.ADV
SLEEP
REC/OTR
POWER
SPEED
STATUS/EXIT
STOP
PLAY
F.FWD REW
MEMORY
SLOW
MUTE
VCR PLUS+
/ENTER
SMART
PICTURE
SKIP
SEARCH
INDEX
SEARCH
EJECT
MENU CLEAR
PAUSE/STILL
CCZ134comb 4/5/99 9:30 PM Page 41