Multiquip MQ Power Whisperwatt 50 Hz Generator DCA10SPXU4 - Manual (Page 31)

DCA10SPX4/DCA10SPXU4 — OPERATION AND PARTS MANUAL — REV. #0 (08/05/09) — PAGE 31
1
Normal Shutdown Procedure
To shutdown the generator use the following procedure:
1. Place both the main, GFCI, and aux. circuit breakers
as shown in Figure 20 to the OFF position.
2. Set the Speed Control Switch to the START/IDLE
position as shown in Figure 22 and let the engine cool
for 3-5 minutes with no load applied.
3. Turn the ignition key counter-clockwise to the STOP
position. When the engine has stopped, remove key.
Place key in a safe place where it will not be lost.
4. Inspect entire generator for any damage or loosening of
components that may have occured during operation.
DCA10SPX4/DCA10SPXU4 — GENERATOR SHUT-DOWN PROCEDURES
Emergency Shutdown Procedure
1. Turn the ignition key counter-clockwise to the STOP
position. When the engine has stopped, remove key.
Place key in a safe place where it will not be lost.
2. Place both the main, GFCI, and aux. circuit breakers
as shown in Figure 20 to the OFF position.
NEVER stop the engine suddenly except in an emergency.
WARNING - SHUTTING DOWN THE GENERATOR