beautypg.com

Problem possible solution – MITSUBISHI ELECTRIC NETCOMMAND 2.0 HD-5000A User Manual

Page 20

background image

20

• There is no audio and video from the IEEE  device.

• The device is not turned on - turn the device power on.

• No media (tape or disc) is inserted into the device.

• The media is blank (has no recording).

• The play command failed - Try pressing play again on the

device’s remote control or front panel.

• The device is already in use (for example the device is currently

recording).

• The source is copy-protected or violates copy-protection.

• The device’s digital video signal is not supported by the TV, such as

DV video common with camcorders. Use analog connections instead,

if available.

• The device is not an audio/video device.

• Too many other devices are already communicating over

IEEE . Remove or stop some devices and try again.

• The IEEE  device cannot be selected.

• Both IEEE  devices and Ant-DTV can not be displayed in the

PIP.

• The device may be busy, either recording or a peer-to-peer

connection has been established. Cancel the recording or

peer-to-peer connection.

• The IEEE  Device is not listed in the Device Selection

menu.

• The device is unchecked in the Review screen.

Go to Setup in the Main menu, select Edit NetCommand Setup,

then select Review. Verify the device is checked.

• The IEEE  plug is disconnected or loose.

• The IEEE  Device has not been powered On. Turn on the

device’s power.

• The device has not been discovered.

• The device is not an Audio/Video device.

• Cannot record to or from the IEEE  device, including Dub

recordings

• To initiate a recording to IEEE  device, first select the

source device to record, such as Ant-DTV (NOT the recording

device). Then press the REC key. The Record/Connect menu

displays allowing setup of the recording.

• The source device for the recording is not powered on.

• For a dubbing, the destination device for the recording is not

powered on.

• The wrong media, (analog tape for digital recording, or

digital tape for the analog recording) is in the device.

• Either the program is copy protected, or if there are multiple

subchannels and one of the programs (not necessarily the

program requested) is copy protected.

• The program has already been recorded once and the copy

protection only allows one recording.

• Unapproved source device for copy protected material.

• The recording device can not decode the copyright signal

included in the signal source (try another device if available).

• The playing device (for dubbing) does not support copyrighted

material.

• Source for recording is copyrighted.

• Too many IEEE  devices in network. Insufficient bandwith

available. Disconnect unused devices.

• Source Device has higher speed (S ) than record device. If

possible, reverse devices, play in the slower device and record in

the faster device.

• DEVICE MENU button does not display a menu.

• The IEEE  device does not provide a menu.

• Cannot control the IEEE  device from the Transport Menu.

• Device may not support the command.

• Selected function is gray (such as Record for a DVD, which does

not support the Record function.

Problem

Possible Solution