MITSUBISHI ELECTRIC NETCOMMAND 2.0 HD-5000A - Manual (Page 12)

12
Transport Menu
Displaying the Transport Menu
(Figure 12)
Selecting a VCR or DVD Player from the Device Selection
menu will automatically display the Transport menu. This
menu is also displayed when one of the transport buttons
on the remote control is pressed while viewing these
devices. You can re-display this menu by pressing the
Device Menu button.
Using the Transport Menu
When the Transport menu is displayed, you can select
transport functions on the menu using the ADJUST
buttons and then select the function by pressing ENT(er).
For example, if you want to pause playback, use ADJUST
to scroll over to the PAUSE key. Then press ENT(er) to
pause.
To directly access a transport function, without using the
ADJUST and ENT(er) buttons, you may press the desired
function button on the remote control (Figure ) .
Please note that if a function is not possible, such as record
for a DVD Player, the Transport menu button will be
grayed out.
You can turn off the automatic display of the transport
menu in the Setup menu of the HDTV Receiver. See the
HD  Owner’s Guide for instructions. When turned
off, the transport menu will not be displayed when you
select VCR or DVD Player on the Device Selection menu,
or press a transport button, or the Device Menu button.
However, even when the Transport menu is turned off,
you can continue to operate the Transport functions of
NetCommand® devices by pressing the transport control
buttons on the remote control.
Figure 12. Transport Menu.
Main Picture