Mobi Technologies MOBICAM 70062 - Manual (Page 9)

• Remove the battery from the Monitor during long periods of non-use.
• Unplug the AC adaptors from the Monitor and Camera during periods of non
use. To disconnect from the power supply, grip the transformer and pull from
the power socket. Never pull by the cord.
• Replace battery with the same equivalent type. Please dispose of old, defective
batteries in an environmentally friendly manner in accordance with the rel-
evant legislation.
• Only use the Monitoring System with the supplied power adaptors.
Battery Installation & Setup
The MobiCam ® Digital Wireless Monitor is designed to be powered by either
batteries or the provided AC/DC adaptor. Reconnect the monitor to the adaptor
whenever possible to maintain battery life. The LED power indicator (4) on the
monitor will be illuminated when the monitor is turned on.
Note: We recommend that you charge the Monitor for at least 8 hours before
operating your Color Wireless Monitor.
Using AC/DC Adaptor
• Check that only the approved Li-ion rechargeable battery is installed in the
monitor.
• Plug the connector of the AC adaptor to the socket on the unit (7 & 20).
• Plug the adaptor into a household electrical socket.
• Switch on the power switch of the unit.
Battery Charge Remaining (when not connected to a charger)
• GREEN = fully charged (4).
• AMBER = low battery, recharge for continuous operation (4).
We recommend that you charge battery for 5-6 hours to fully charge. Battery
will last approximately 4-4.5 hours when unit is constantly on. In VOX mode
unit will last approximately 8-10 hours.
WARNING: The monitor of your MobiCam ® Digital Wireless System has a
built-in recharging circuit. Before plugging in either AC adaptors, please make
sure only the approved rechargeable Li-ion batteries (or no batteries) are inside
the battery compartment.
7