Marantz DLP PROJECTOR VP-12S2 - Manual (Page 36)

32
ENGLISH
❖
Optical characteristics
Panel 0.8 inch 16:9
1280 x 720 pixels
Digital Micromirror Device
TM
Lamp Super High Pressure 150W
Lens f: 26.5 to 30.7 / F: 3.0
Projection size 40 to 250 inches
Light output 700 ANSI LUMEN typical
❖
Input/Output
VIDEO IN RCA x 1
NTSC-3.58/PAL-4.43/SECAM
Composite video 1.0Vp-p/75 Ohm
S-VIDEO IN S-Connector x 1
NTSC-3.58/PAL-4.43/SECAM
S-Video
COMPONENT IN RCA x 3
Y, C
B /P B , C R /P R
RGB/HD IN D-sub M 15 pin x 1
Analog RGB
HD:1080i, 720p, 480p
DVI-D IN DVI-D 24pin x 1
T.M.D.S compliant (single link only)
☞
P.33
REMOTE CONTROLLER IN
Mini jack type x 1
REMOTE CONTROLLER OUT
Mini jack type x 1
AC IN 3 Prong Grounding Type
TRIG.1 OUT, TRIG.2 OUT
Mini Jack x 2
Output: DC12V or 0V
RS232C RS232C receptacle plug x 1
❖
General
Power requirement AC 100-120V / 220-240V, 50/60 Hz
Power consumption < 250 W
Standby consumption < 3.3 W
Chassis isolation Class-1
Safety UL6500
CSA E60065
EN60950
EMC FCC Part-15 Class-B
EN55022 Class-B
Dimensions 404.5(W) x 471(D) x 158(H) mm
Net weight 13 kg
Operating Temperature 5 to 35 °C
Operating humidity 30 to 85%
Storage Temperature – 20 to 60 °C
Storage humidity 30 to 85%
❖
Accessories
• Lens cap x 1
• Remote controller x 1
• Batteries x 2
• AC power code x 1
• Control Adapter cable (Mini jack to RCA) x 1
• Scart - RCA plug Cable x 1
• User Guide x 1
Specifications may be subjected to change without any prior notice.
SPECIFICATIONS
NO SIGNAL
REPLACE LAMP!
OUT OF RANGE
No input signal.
The lamp has reached the end of its life.
Improper signal feed to the projector.
Properly connect the cables.
Replace the lamp and reset lamp life.
Adjust resolution, V(Hz) : refresh rate of the
equipment, referring to the Timing Chart.
Meaning Message Remedy
Use the list below to check the message displayed on the screen.
ON SCREEN MESSAGE