Marantz DLP PROJECTOR VP-12S2 - Manual (Page 13)

9
ENGLISH
You can connect this projector to HD-Video /PC using RGB IN port, or Satellite /Cable Tuner /PC using DVI-D IN port.
1. Connect one end of the RGB cable to the RGB IN port, or one end of the DVI-D cable to the DVI-D IN port on the projector.
2. Connect the other end to the corresponding port on a HD-Video, Satellite, Cable Tuner or personal computer.
Note : When projecting a video image from a device connected to the DVI-D terminal, follow the procedure below.
1. Turn on power of this unit. (
☞
P.15)
2. Set the input video source to AUX (DVI-D input). (
☞
P.15)
3. Turn on power of the device connected to the DVI-D terminal of the unit (i.e. DVD player).
If the procedure above is not followed, projected image may corrupt.
For the details of the DVI-D terminal on the device connected with the unit, see the instruction manual of the device.
You can control total home theater system using PC or Marantz receiver equipment.
For installing below system, consult with Marantz authorized dealer.
Receiver equipment
External Controller
Screen
REMOTE CONTROL IN
REMOTE CONTROL OUT
RS-232C
35mm Mini Plug (Mono)
(commercially available)
Control Adapter cable
(supplied)
RS-232C cable
(straight type, commercially available)
(commercially available)
Advanced Connection
IBM VGA or
Compatible PC
HD-Video / Satellite
/ Cable Tuner
RGB OUT
or
DVI-D out
RGB (D-Sub monitor) cable
(commercially available)
Monitor output
RGB OUT
or
DVI-D out
DVI-D cable
(commercially available)
Connection with a HD-Video, Satellite, Cable Tuner or PC