Murray 309001x18A - Manual (Page 11)

ASSEMBLY
11 F–030610L
HOW TO INSTALL THE SEAT
Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
(A)
1001054
(B)
17x47
1. Carefully remove the plastic bag from the seat.
2. Raise the seat support and secure in the UP position with the
seat support rod.
3. Align the holes in the seat to the holes in the seat support
(Figure 1). Fasten the seat to the seat support with the fasten-
ers as shown.
4. Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts (A). Slide the seat for-
ward or backward along the seat adjusting holes as shown.
Tighten the wing bolts (A).
Figure 1
Seat
Seat
Adjusting Hole
Seat Support
A
B
Seat Support Rod
HOW TO ASSEMBLE THE STEERING WHEEL
Attach the steering wheel as follows:
1. Make sure the front wheels point forward.
2. Slide the steering wheel and steering post into the console.
Push on the steering wheel. The steering post will lock onto
the pinion gear. Pull on the steering wheel. Make sure that the
steering post is locked in place.
Steering Wheel
Figure 2
Steering Post
Console