Measurement Specialties PCI-QUAD-AC5 - Manual (Page 11)

PCI-QUAD-AC5 User's Guide Installing the PCI-QUAD-AC5
Optional components
You can also order the following MCC products to use with your PCI-QUAD-AC5.
Cables
C50FE-x C50FF-x
Signal termination and conditioning accessories
MCC provides signal conditioning and termination products for use with the PCI-QUAD-AC5. Refer to
Field wiring and signal termination on page 2-6 for a complete list of compatible accessory products.
If any items are missing or damaged, notify Measurement Computing Corp. immediately by phone, fax,
or e-mail:
ƒ Phone: 508-946-5100 and follow the instructions for reaching Tech Support.
ƒ Fax: 508-946-9500 to the attention of Tech Support
ƒ Email: [email protected]
Unpacking the board
The PCI-QUAD-AC5 board is shipped in an antistatic container to prevent damage by an electrostatic
discharge. To avoid such damage, perform the following procedure when unpacking and handling your
board.
1.
2.
3.
Before opening the antistatic container, ground yourself with a wrist-grounding strap or by holding
onto a grounded object (such as the computer chassis).
Touch the antistatic container to the computer chassis before removing the board from the container.
Remove the board from the container. Never touch the exposed pins or circuit connections on the
board.
If your board is damaged, notify Measurement Computing Corporation immediately by phone, fax, or
e-mail. For international customers, contact your local distributor where you purchased the board.
ƒ Phone: 508-946-5100 and follow the instructions for reaching Tech Support.
ƒ Fax: 508-946-9500 to the attention of Tech Support
ƒ Email: [email protected]
2-2