MITSUBISHI ELECTRIC WT - 42313 - Manual (Page 21)

20
21
Connecting MonitorLink™
Figure 14. Connecting MonitorLink
MonitorLink
(Figure 14)
1. Connect a MonitorLink/DVI cable from the
TV back panel to the Mitsubishi HD Receiver/
Controller back panel.
2. Connect the MonitorLink Control/RS-232 cable
from the TV back panel to the Mitsubishi HD
Receiver/Controller back panel.
3. Connect the L (left) and R (right) audio cables
from the HDTV receiver to AUDIO LEFT and
AUDIO RIGHT on the MonitorLink section of
the TV back panel.
NOTE: The 29 pin MonitorLink/DVI and RS-232
cables can be found at your local electronics
store.
CAUTION: To assure continued FCC
compliance, the user must use a shielded video
interface cable with bonded ferrite cores at each
end, when using the MonitorLink/DVI input.
Note: The TV back panel and connections shown here are for reference only and may vary by model.
AUDIO- LEFT/ (MONO)
AUDIO- RIGHT
WS-48313, WS-55313, WS-65313
back panel
403XF-5K
1
1
2
2
OUTPUTS
TO
DISPLAY
1 2 3 4 MONITOR PIP
INPUT
TO
AV RECEIVER
AC IN
DIGITAL AUDIO OUTPUT MonitorLinkTM
/DVI
MonitorLink TM
CONTROL/RS-232 IR OUTPUT NetCommand R
S-VIDEO
VIDEO
AUDIO
LEFT
AUDIO
RIGHT
White
Red
MitsubishiHD-5000
receiver/controller back panel
3
White
Red
3
ferrite
core
ferrite
core
Y
G
Pb
B
P r R V
H
DTV(YPbPr/ GBRHV)
480 i / 480P /1080 i
MONITORLINK TM /DVI
MONITORLINK TM CONTROL RS-232C
40 3X F- 5K