McIntosh MCD201 - Manual (Page 19)

19
5. To cancel the Program Playback
Mode either press the STOP
Push-button followed by pressing
the PGM (Program) Push-button
or press the STOP Push-button
twice.
6. Once the Program Playback Mode
is active, tracks may be added
by first pressing the STOP
Push-button followed by enter-
ing the additional tracks using
the Numeric Push-buttons. Then
press the PLAY Push-button to
resume Program Playback Mode.
7. If you would like to delete a
track(s) once the Program Play-
back Mode is active, first press
the STOP Push-button followed
by pressing the CLEAR Push-but-
ton until the desired track is re-
moved. The MCD201 removes the
last track entered first, followed
by the second last track, etc. Any
new tracks may be added by using
the Numeric Push-buttons. Then
press the PLAY Push-button to
resume Program Playback Mode.
MP3 Disc Playback
The MCD201 has the ability of playing back MP3 encoded
discs. MP3 allows more tracks on the Disc by using the
technique of lossy compression applied to the original
audio information. The MP3 Track has lower audio qual-
ity than the original recording. Load a MP3 disc into the
MCD201. Refer to figure 24.
1. Press the PLAY Push-button to start Playback. Refer
to figure 25. After all the tracks have been played the
MCD201 will stop.
Note: MP3 Discs will only indicate the elapse time and
remaining time for each track as it is playing.
How to Operate the MCD201, con’t
Playback Mode Feature can be activated.
2. When programming Hybrid SACD Discs, first
choose the layer (SACD or CD) so the correct TOC
can be read, as some discs have different selections
for the SACD and CD Tracks.
1. Press the PGM (Program) Push-button to access the
Program Mode. Refer to figures 12 and 19.
2. Enter the first desired selection using the Numeric
Push-buttons. Refer to figures 12 and 20.
3. In a similar manner, enter the remaining Tracks. Refer
to figures 21 and 22.
Notes: 1. The CLEAR Push-button may be used to delete
programmed track(s), starting with the track
entered last.
2. To cancel a Program before starting playback
of the Program, press the STOP  Push-but-
ton.
4. To start playback of the just entered program, press
the PLAY Push-button. The Repeat Mode can be
activated to provide continuous playback of the Pro-
grammed Track(s). Refer to figure 23.
Note: To momentarily stop playback, press the PAUSE
Push-button. To resume Program Playback press
the PLAY  Push-button.
Figure 19
Figure 20
Figure 21
Figure 22
Figure 23
Figure 25
Figure 12
Figure 24