beautypg.com

Cleaning the dust canister filter assembly, Motor protection filter, Exhaust filter – Morphy Richards 73380 User Manual

Page 6: Hints and tips safety cut-out

background image

6

6

Cleaning the dust

canister filter

assembly

1

Operate the filter cleaning dial

fi

several times and empty the

dust canister over a bin.

2

To access the filter assembly

rotate the dust canister lid ◊

anti clockwise and remove from

the dust canister J.

3

Turn the central mesh filter ¯

clockwise to remove and clean

as required K.

4

Detach the pleated filter ˜ from

the dust canister lid ◊ by a firm

pull/twist action L.

5

Both the mesh and pleated

filters may be washed in warm

water (no detergent). Allow to air

dry. Ensure the filters are

thoroughly dry before refitting.

6

Re-locate the pleated filter back

into position on the dust

canister lid by aligning the tabs

on the dust canister lid ◊ L

with the cut away sections on

the pleated filter before pushing

into place.

Refit the mesh filter and turn

anti-clockwise to lock into

position on the dust canister lid.

Re-attach the dust canister lid

on to the dust canister by

aligning the arrows J. Then

rotate the lid clockwise to lock.

Motor protection

filter

The motor protection filter ˘ is

located underneath the dust

canister M.

1

Remove the dust canister.

2

Lift out the filter and shake over

a dustbin. The filter may also be

washed in warm water (no

detergents). Allow the filter to air

dry. Ensure the filter is

thoroughly dry before refitting.

3

Replace the filter.

Exhaust filter

The allergy exhaust filter should

be replaced every 6 months to

maintain the high performance

filtration. Call our helpline.

The exhaust filter is located

below the dust canister

compartment.

1

Remove the exhaust filter grille

‚ N

.

2

Remove the exhaust filter „ by

pulling forward at the top and

lifting away.

3

Fit the replacement filter.

4

Refit the grille.

5

Dispose of the used filter in the

dust bin.

HINTS AND TIPS
Safety cut-out

(Suction motor)
If the cleaner overheats, a motor

protection thermostat will

automatically switch the motor

off. If this happens, switch the

cleaner off, unplug from the

power supply and leave the

cleaner to cool for at least

60

minutes. Check the airways for

blockages, empty dust canister

and clean the filters before

restarting.

M

˘

L

J

K

˜

˜

N

UUKK HHeellpplliinnee 00884444 887711 00994499

RReeppllaacceem

meenntt PPaarrttss 00884444 887733 00771155

IIrreellaanndd HHeellpplliinnee 11880000 440099 111199

73380 rev4 15/2/08 09:23 Page 6