Motorola HF850 User Manual
Page 10
8
Installing the Power Cable and Fuse Kit
Caution: Failure to follow these steps may cause the
accessory not to work properly and may cause damage to the
car kit.
1
Remove all fuses and tape them to their respective
holders. DO NOT re-insert fuses until you complete and
inspect all connections.
2
Connect the fuse kit’s GREEN Ignition Sense wire (3 amp
fuse) to an ignition-switched location on the fuse block.
When the ignition is off, the ignition sense line is low.
Speaker (SSN4020)
Junction Box (SYN1102A)
Microphone
(SMN4095B)
Power Cable
(SKN4834A)
Vehicle
Radio
User
Interface
Module
(SYN1101A)
Fuse Kit (SKN4937A)
Wire Crimps:
green to green,
red to red,
black to black
Black:
to
vehicle
chassis
Red: to a point in
fuse box that is
always active
4 - 5 AMP fuse
Green:
to fuse
box
Orange
Blue
Yellow