Motorola T5300 - Manual (Page 19)

15
T
a
lking an
d Listening
Channel
•
With radio On, press \ , Current Channel will begin to flash.
• Use [ and ] to change Channel while flashing.
• Press
M
to set new Channel.
Interference Eliminator Code (T5400 Only)
The interference eliminator codes help minimize interference by
providing you with a choice of code combinations.
•
To set the code, press \ until the code display begins to blink.
• Then press [ or
]
to set the code.
• Press
M
to save the code setting.
You must set the Interference Eliminator Code to 0 on a T5400 to communicate with
a T5300.
You can specify a different code for each channel. To set a channel and code
combination, press
\
and then press
[
or ] to select the channel. Press
\
again and then press [ or
]
to select a code. Press M to exit the menu and to
save the channel and code combination. To set another channel and code
combination, repeat these steps.
Volume
•
Rotate P while holding down Q until you reach a comfortable listening level.
• Rotate P clockwise to increase and counter-clockwise to decrease volume.
6864110r09o.book Page 15 Friday, December 21, 2001 12:04 PM