M-S Cash Drawer A794 - Manual (Page 86)

A794 Owner’s Guide Chapter 6: Programming Information
December 1999 81
Set Right-Side Character Spacing
ASCII ESC SP n
Hexadecimal 1B 20 n
Decimal 27 32 n
Range of n: 0 – 32
Default: 0
Sets the right side character spacing to [n x horizontal or vertical motion units]. Values
for this command are set independently in standard and Page Mode.
The units of horizontal and vertical motion are specified by the Set Horizontal and
Vertical Minimum Motion Units (1D 50 …) command. Changes in the horizontal or
vertical units do not affect the current right side character spacing. When the horizontal
or vertical motion unit is changed by the Set Horizontal and Vertical Minimum Motion
Units (1D 50 …) command the value must be in even units and not less than the
minimum amount of horizontal movement.
In Standard Mode the horizontal motion unit is used.
In Page Mode the horizontal or vertical motion unit differs and depends on the starting
position of the printable area. When the starting printing position is the upper left or
lower right of the printable area (set by Select Print Direction in Page Mode, 1B 54 n) the
horizontal motion unit (x) is used. When the starting printing position is the upper right
or lower left of the printable area (set by Select Print Direction in Page Mode, 1B 54 n)
the vertical motion unit (y) is used.
Related Information
This is ignored in TM-T88 Emulation and the parameter byte goes into the print buffer.
In the A793 Emulation, the command and parameter byte are ignored.