Supplied accessories, Attaching the stand, Symbols used in this manual – Philips Magnavox 22MF339B User Manual
Page 5
5
EN
INTRODUCTION
PREPARATION
WATCHING TV
OPTIONAL SETTING
TROUBLESHOOTING
INFORMATION
Supplied Accessories
AAA
AAA
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
user manual
(1EMN24239A)
quick start guide
(1EMN24541)
remote control
(NF802UD)
batteries
(AAA x 2)
screw kit for attaching
the stand
(1ESA19876)
o the part No. with
ual
e controll
2UD)
batte
b
(AAA
Attaching the Stand
You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the
proper direction.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
1
Spread a thick and soft cloth over a
table as shown below.
Place the main unit face down onto it.
2
Align the 2 stand hooks with the two
hooks under the bottom of the main
unit (shown by arrow
➀
), then slide
the stand in the direction as shown
by arrow
➁
until it stops and the 3
mounting holes are aligned.
Make sure not to put the AC power
cord between the stand and the
unit.
3
Drive Phillips pan screws in the 3
threaded holes at the bottom of the
stand until they are tight.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by above “
➂
” screw holes. After the screws are removed pull the stand up toward the rear of the
unit. Be careful not to drop the stand when you remove it.
screw holes
front side
front side
Symbols Used in this Manual
The following is the description for the symbols used in this manual. Description refers to:
TV
: Analog TV operation
DTV
: Digital TV operation
• If neither symbol appears under the function heading, operation is applicable to both.