MSI MS-7181 - Manual (Page 40)

3 - 2
M S-7181 M icro-ATX M ainboard
Entering Setup
Power on the computer and the system will start POST (Power On Self Test) process.
W hen the message below appears on the screen, press key to enter Setup.
Press DEL to enter SETUP
If the message disappears before you respond and you still wish to enter Setup,
restart the system by turning it OFF and On or pressing the RESET button. You may
also restart the system by simultaneously pressing , , and keys.
Selecting the First Boot Device
You are allowed to select the 1st boot device without entering the BIOS setup utility
by pressing . W hen the same message as listed above appears on the screen,
press to trigger the boot menu.
The POST messages might pass by too quickly for you to respond in time. If so, restart
the system and press after around 2 or 3 seconds to activate the boot menu
similar to the following.
The boot menu will list all the bootable devices. Select the one you want to boot from
by using arrow keys, then press . The system will boot from the selected
device. The selection will not make changes to the settings in the BIOS setup utility,
so next time when you power on the system, it will still use the original first boot
device to boot up.
Select First Boot Device
Floppy : 1st Floppy
IDE-0 : IBM-DTLA-307038
CDROM : ATAPI CD-ROM DRIVE 40X M
[Up/Dn] Select [RETURN] Boot [ESC] cancel