Marvel Industries 6SWCE - Manual (Page 6)

CUSTOM WOOD FRAME INSTALLATION INSTRUCTIONS
5
STEP 5: ATTACHING THE WOOD FRAME TO THE DOOR
(WITHOUT THE LOCK AND KEY FEATURE)
If the door is attached to the unit, remove it by un- 1.
screwing the top Allen head set screw at the top hinge.
Remove the door by angling the door off of the bottom
hinge pin.
Peel back door gasket to expose the screw holes.
2.
Set the wood frame flush to the front of the door in the 3.
desired location. Clamp wood frame to the door if
necessary.
Insert the wood screws through the back of the door
4.
into the pilot holes in the overlay panel and tighten.
Reinstall door gasket by pressing into door channel.
5.
Make certain the corners are inserted fully.
Install the door to the unit. Use the supplied plastic
6.
washers as shown in Figure 7.
Realigning the door may be necessary. Any final door
7.
adjustments can be made using a 5/32 inch Allen
head driver to adjust the door’s hinges (see Figure 7).
Attach the door light striker plate as shown using the
8.
Hex or Phillips head screws provided. Make certain the
light is able to turn on and off when the door is opened
and closed.
Attach the door to the unit by reversing step number 1
9.
above.
Figure 7: Hinge Hardware Installation Details
CAUTION
Door can become
disengaged if washers
are not installed.
CAUTION
Door can become
disengaged if washers
are not installed.
2 Nylon Hardware
Components at
Bottom Hinge
CAUTION
Door may not swing
properly- if all nylon
components are not
installed as shown.
Wood
Frame
Door Hinge
.75 OD x
.443 ID
Washer
.75 OD x
.257 ID Washer
3 Nylon Hardware
Components at
Bottom Hinge
Bottom Hinge Corner
Cabinet Hinge
0.625 OD x 0.218 ID Washer
Shoulder Bushing
Door Hinge
Wood Frame
Top Hinge Corner
Magnetic Door Gasket
0.38 Clearance Holes
for Frame Wood Screws
8 Holes
5/32 inch Allen Head Screws
for Hinge Adjustment
Light Door Striker Plate
Bottom of Door
Door Hinge
Adjustment Screws
Attached
Wood Frame