Marvel Industries 6SWCE - Manual (Page 4)

Remove the nameplate for the glass door by gently pulling
it up and away from the glass surface. Relocate the name-
plate using the supplied nameplate locator (part number:
41006022).
CUSTOM WOOD FRAME INSTALLATION INSTRUCTIONS
Figure 5: Nameplate Locator
2.38
STEP 4: DETERMINING DOOR SWING
The door you received is for a right hand swing unit. If the
unit is to be changed to a left hand swing door, pre-drilled
striker plate holes are in place on the backside of the door
on both ends. No additional drilling is necessary to mount
the striker plate when you reverse the door swing. Just
unscrew the striker plate from the location it is mounted to
for right hand swing and then mount the striker plate at
the end opposite of its previous location with the existing
screws.
If your door has an inner door liner with formed in shelves,
it will need to be turned around for use in the left hand
swing. Using a small, flat blade screwdriver, pop the plas-
tic screw covers up to access the Phillips screws that secure
the formed door liner to the door. Using a Phillips screw-
driver, remove the Phillips screws that secure the formed
door liner to the door. Rotate the formed door liner 180
degrees, line up the mounting holes in the door liner with
the mounting holes on the door. Use the existing fasteners
and plastic screw caps to secure the formed door liner to
the door. Your door swing conversion is complete.
Holes for screws to mount striker
plate are already pre-drilled at
factory.
New Door Bottom
for Left Hand Swing
Door
Striker Plate for Plunger Light
Switch
Figure 4: Striker Plate Hole Location
3