Philips Magnavox MDV540VR/17 - Manual (Page 39)

DVD to Videotape Duplication 39
Follow the steps below to copy a DVD to a videotape. This
will be possible only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the
tape’s record tab is intact and the tape is long enough
to record the DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so the VCR light appears on the front of the
DVD/VCR.
● Turn on the TV and set it to channel 3, 4, or its Video Input.
1 Point the remote control at the DVD/VCR. Press
Number buttons 0, 0, 3. “DISC” will appear on
the TV screen.
2 Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the TV. Details about tape
speed are on page 72.
3 Press REC I to start recording. REC will appear on
the display panel.
4 Press DVD. Press PLAY B to play the disc.
5 To pause the recording, press VCR, then press
PAUSE k once. REC will flash. To resume recording,
press REC
I or press PAUSE k again. REC will
reappear.
6 To stop recording, press VCR, then press STOP C.
DISC
TIMER SET
SETUP SUBTITLE AUDIO
MODE
DISPLAY
TITLE
PREV/
CH
NEXT/
CH
RETURN
A-B
DVD
PLAY STOP
SEARCH
FF
PAUSE
SPEED NA508
SEARCH
REW
VCR
DISC
REPEAT
C-RESET
CLEAR
REC REPEAT
ANGLE
STANDBY-ON
2 3 1
SLOW
5 6 4
8 9 7
SEARCH MODE ZOOM
0 +10
MENU OK
• A timer recording is not possible
during DVD to videotape
duplication.
• You cannot copy a DVD to a
videotape if you are using
Progressive Scan. Details are on
page 12.
Helpful Hints
2
4
1
3,5
5
6
5,6
H9660UD_1.qx4 04.4.14 4:47 PM Page 39