beautypg.com

Iii. dx-vs1ue initial configuration, Installation summary, Connecting – MITSUBISHI ELECTRIC DX-VS1 User Manual

Page 11: Dx-vs1ue initial configuration

background image

DX-VS1UE User

DX-VS1UE User

DX-VS1UE User

DX-VS1UE User’’’’s Manual

s Manual

s Manual

s Manual

10

III.

DX-VS1UE Initial Configuration

1.

1.

1.

1.

Installation Summary

Connect ethernet cable and supply power to DX-VS1UE on local network for configuration.

Install a setup program of DX-VS1UE in a PC on local network.

Assign an IP address to DX-VS1UE and set administrator condition.

Set user condition.

2. Connecting

2. Connecting

2. Connecting

2. Connecting

Connect ethernet cable to the ethernet port on the rear.

Connect power supply unit to a power supply port on the rear..

Confirm that the LEDs of ethernet port keep blinking.

Connecting DX-VS1UE with PC
You may use crossover cable (red colored one) to directly connect DX-VS1UE to a PC.

*If you use the crossover cable (red colored one) enclosed and follow the method illustrated in the

above diagram, but you cannot access, try to connect through HUB using direct cable. Otherwise,

set 10Mbps to the communcation speed in terms of network interface configuration of your PC, if

it’s possible. In case you cannot access even though you tried the above mentioned method, some-

thing can be wrong with PC(including OS setting). Please contact with makers which provide your

PC or OS.

Crossover Cable

Connect DX-VS1UE directly

to PC through LAN ports.

Note in connecting cable to terminal block

When you connect cable to terminal block, you should peel off the cover of cable by 1.5cm and

insert the cable by 2cm into the terminal block.(communication., sensor input, alarm and etc).

The white line on cover of power cable indicates “+”.