Multiquip MQ Power Ultra-Silent 50 Hz Generator DCA-125USJ - Manual (Page 42)

PAGE 42 — DCA-125USJ (50 HZ) — OPERATION AND PARTS MANUAL — REV. #0 (03/11/05)
Shutdown Procedure
To shutdown the generator use the following procedure:
1. Place both the MAIN, GFCI and LOAD circuit breakers
as shown in Figure 39 to the OFF position.
3. Let the engine cool by running it for 3-5 minutes with no
load applied.
4. Place the MPEC Control Switch (Figure 55) to the
OFF/RESET position.
Figure 55. MPEC Control Switch (Off/Reset)
5. Verify that the all status LED on the MPEC display
are OFF (not lit).
6. Remove all loads from the generator.
DCA-125USJ (50 HZ)— GENERATOR SHUT-DOWN PROCEDURE
NEVER stop the engine suddenly except
in an emergency. DO NOT use the
emergency stop switch a as method of
shutting down the generator. This switch is
ONLY to be used in the event of an
emergency.
CAUTION CAUTION CAUTION CAUTION CAUTION: Emergency Shutdown Procedure
1. To shut-down the engine in the event of an emergency,
switch the MAIN, GFCI and LOAD (Figure 39) circuit
breakers to OFF position.
2. Place the MPEC Control Switch switch (Figure 55) to
the OFF/RESET position.