Memorex MPH7895 - Manual (Page 20)

B. ERASING ALL ICM AND TWO-WAY RECORDINGS
1.
In standby mode, press and hold the ERASE button for about 2 seconds.
2. The unit will announce "Message (number) erased. You have no message."
C. ERASING ALL MEMO MESSAGES
1.
In standby mode, press the ERASE button briefly for less than
2 seconds and press and hold MEMO button for about 2 seconds.
2. The unit will announce "Message erased. You have no Memo
message".
D. ERASING OGM
1.
During OGM playback, press ERASE button.
2. The unit will announce "Erase your announcement. You have no announcement."
NOTE: After erasing messages during memory full or near memory full, you may hear a
continuous beep for several seconds indicating memory sorting of the unit.
MEMORY FULL DETECTION
The memory full condition occurs:
•
• • • • If 15 minutes of recording time is reached, or
• • • • • If 59 messages (i.e. Memo, OGM, ICM) have been recorded.
In this case, the LCD Display shows “FU” in answer on mode. If there is an incoming call,
the unit will answer at the 10th ring and announce "Memory full". You can erase any or all
the messages remotely after listening to them. Refer to the REMOTE OPERATION section
for more details.
NOTE: Sometimes you may fail to escape from memory full condition when erasing a short
message. In this case, you must erase more messages (at least 1 minute message).
CALL SCREENING
You can listen to the caller leave their ICM and decide if you want to answer the call.
A. FROM THE HANDSET (Away From the Base Unit)
1.
When the unit rings, press the REMOTE button
on the handset. The unit will immediately answer
the call. You will hear your OGM followed by the caller's
message through the handset receiver.
2. If you decide to take the call, simply press the TALK button and begin speaking.
B. FROM THE HANDSET (In the Base Unit Cradle)
1.
When the unit answers a call, you will hear your OGM followed by the caller's message
through the base unit's speaker.
2. If you decide to take the call, simply pick up the handset. Begin speaking and the ICM
recording is stopped. The recorded message is stored in memory and the message
count is incremented by one.
C. FROM THE EXTENSION PHONE
1.
When the unit answers a call, you will hear your OGM followed by the caller's message
through the speaker.
2. If you decide to take the call, just lift the handset of the extension phone on the same
line as the unit and the ICM recording is stopped. The recorded message is stored in
memory while the message count is incremented by one.
TWO-WAY RECORDING
Two-Way Recording allows you to record your conversation with another caller. Two-Way
Recording can be enabled during TALK mode while you are using the handset. Two-Way
Recording(s) is stored in Message (MSG) box.
1.
While in TALK mode, press and hold the PAGE / 2-WAY
REC button of the base.
2. Release the PAGE / 2-WAY REC button to
end your Two-Way recording.
19
(Figure 25)
(Figure 26)
(Figure 27)
MPH7895/04281A(English).put 7/5/01, 4:08 PM Page 20 Adobe PageMaker 6.5C/PPC