Preparation for use, Speaker connection, Ac connection – Memorex MX4137 User Manual

Page 5: Remote battery installation

PREPARATION FOR USE

SPEAKER CONNECTION

1. Place the speakers in convenient locations on either side of the unit.

Usually a distance of five to eight feet between speakers provides the

best stereo effect, but this may vary depending on the size and

acoustics of the room.

2. Locate the Speaker Jacks on the rear of the unit and connect the

dashed black wires to the red (+) terminals and connect the solid

black wires to the black (–) terminals.

3. To connect the speakers, press the terminal down, insert the speaker

wire and press the terminal back to the lock position.

4. Pull lightly on the connection (as shown) to make sure it is secure.

CAUTION: Only connect the speakers which are supplied with the unit. The use of any other or additional

speakers may cause damage to the unit. Never operate the unit without the speakers connected.

AC CONNECTION

Unwind the AC cord and extend it to its full length. Insert the AC plug into

any convenient 120V 60Hz household outlet.

Please note that this unit is equipped with a polarized AC plug which has

one blade wider than the other. This is a safety feature to reduce the

likelihood of electric shock. This polarized AC plug will only fit in a

polarized AC outlet. If you find that you cannot insert this plug into your

outlet, you may have an obsolete non-polarized outlet. Please do not try

to defeat this safety feature by using a non-polarized adapter or by filing the wider blade to make it fit into

your outlet. If this plug does not fit into your outlet, you should contact a qualified licensed electrician to

replace your obsolete outlet.

AC Plug

AC Outlet

REMOTE BATTERY INSTALLATION

BATTERY PRECAUTIONS

Follow these precautions when using a battery in this device:

1. Use only the size and type of battery specified.

2. Be sure to follow the correct polarity when installing the battery as indicated in the Battery Compartment. A

reversed battery may cause damage to the device.

3. If the device is not to be used for a long period of time, remove the battery to prevent damage or injury from

possible battery leakage.

4. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery

manufacturer’s directions.)

1. Remove the Battery Compartment (on the bottom

rear of the remote control) by pressing in on the

tab and then sliding the compartment out.

2. Install a CR2025 battery, paying attention to the

polarity diagram in the Battery Compartment

(positive side up).

3. Replace the Battery Compartment.

–