Meridian America D-ILA 1080MF1 - Manual (Page 10)

10
A Control Panel Cover
Remove this cover when operating this unit or
when replacing the lamp unit.
• Unlock the cover, followed by sliding it down-
wards to remove it.
• Please refer to page 11 for details on the con-
trol panel.
Handling the Control Panel Cover
• The gap between the body of the unit and the
control panel cover is narrow. Be careful not to
stick your finger into the gap between the body
of the unit and the control panel cover.
• After attaching the control panel cover, check
that the lock is fastened securely.
B Exhaust Vent
Warm air is expelled through this vent to keep
the system cool. Do not block the exhaust
vents as this may cause the unit to overheat
and fail.
C AC Power Input Socket
This is the AC power input socket. Connect
the supplied power cable to this socket.
D Remote Sensor (Rear)
When operating with the remote control, aim
it towards the sensor. (Page 14)
• A remote sensor is also located at the front of
the unit.
E Screen Trigger socket
This socket is used for controlling a motorised
screen. An output at DC +12 V/100 mA (max.)
is produced when the power is on.
• Consult a qualified technician for a connection
with the screen.
F Service Connector
This connector is intended for servicing pur-
poses and should not normally be used.
G RS-232C Serial Port (D-sub 9 Pin)
The projector can be controlled by serial com-
mands from a computer or home automation
control system connected to this port.
• For details, please check with your authorized
dealer.
H DVI input (DVI-D 24 Pin)
This is the input socket for video signals.
1080/50p and 1080/60p signals are supported
and HDCP content protection capability is
provided.
Rear & Right Side
DVI RS-232C SCREEN TRIGGER SERVICE
A
C
B
E F G H D
Removing the control
panel cover
Lock
Release