Moxa Technologies 5600 - Manual (Page 36)

NPort 5600 Series User’s Manual Web Console Configuration
Port alias
Setting Factory Default Necessity
1 to 15 characters
(E.g., PLC-No.1) None Optional
“Port Alias” is specially designed to allow easy identification of the serial devices which are
connected to NPort’s serial port.
Serial Parameters
Check the serial communication parameters in your Serial Device’s user’s manual. You should
set up NPort’s serial parameters with the same communication parameters used by your serial
devices.
Baud rate
Setting Factory Default Necessity
50 bps to115.2 Kbps 115.2 Kbps Required
Data bits
Setting Factory Default Necessity
5, 6, 7, 8 8 Required
When the user sets Data bits to 5 bits, the stop bits setting will automatically change to 1.5 bits.
Stop bits
Setting Factory Default Necessity
1, 2 1 Required
Stop bits will be set to 1.5 when Data bits is set to 5 bits.
Parity
Setting Factory Default Necessity
None, Even, Odd, Space, Mark None Required
5-10