beautypg.com

Menu operation (continued) – MITSUBISHI ELECTRIC XD420U User Manual

Page 16

background image

EN-16

Menu operation (continued)

1 IMAGE

CONTRAST ................................................Use to adjust the image contrast. The contrast becomes

higher as the value increases.

BRIGHTNESS.............................................Use to adjust the image brightness. The image becomes

brighter as the value increases.

WHITE ENHANCE......................................Use to adjust the white level of the projected image.

Select AUTO for normal use.

COLOR TEMP. ...........................................Use to adjust the color temperature. See page 18.

COLOR .......................................................Use to adjust the color intensity of the image.

TINT ............................................................Use to adjust the color balance of the image. The color

balance shifts to green as the value increases and shifts
to purple as the value decreases. (Available only when
VIDEO or S-VIDEO is chosen as the source.)

When the TV50 (PAL, SECAM) signal is input, TINT
can’t be adjusted.

SHARPNESS..............................................Use to adjust the image sharpness. The image becomes sharp as the value increases. (Not available

with certain signals.)

GAMMA MODE ..........................................When AUTO is selected, the appropriate gamma mode is automatically selected depending on the

input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select STAN-
DARD for sport scenes and video sources. Select THEATER for film sources.

2 INSTALLATION

AUTO POWER ON .....................................When ON is chosen, the lamp is automatically lit when

the power cord is plugged in the wall outlet. Choose ON
when using the projector mounted on the ceiling.

The projector is in the stand-by mode when the lamp
is off. Use the remote control to turn on the lamp.

AUTO POWER OFF....................................Use to set the time elapsed before the projector enters

the stand-by mode when there is no signal input from the
source.

SPLASH SCREEN......................................Choose ON to display the splash screen when the power

is turned on.

BACK COLOR.............................................Use to select the background from among BLUE and

BLACK, which will be displayed when there is no signal input from the source.

LAMP MODE ..............................................Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness is kept low and

the projector operating noise is reduced, resulting in a longer lamp replacement interval.

When the lamp mode is switched, the projected image may flicker. This is not a product malfunc-
tion.

Do not change the setting of LAMP MODE frequently.

When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW
about one minute after turn-on.

IMAGE REVERSE ......................................Use to reverse the projected image. Select MIRROR for rear projection with the tabletop-mounted

projector. Select MIRROR INVERT for front projection with the ceiling-mounted projector.

CONTRAST

IMAGE

0

BRIGHTNESS

0

STANDARD

0

COLOR

AUTO

0

XGA60

WHITE ENHANCE

AUTO

TINT

0

SHARPNESS

COLOR TEMP.

GAMMA MODE

opt.

INSTALLATION

opt.

ON

BACK COLOR

AUTO POWER
ON

AUTO POWER
OFF

SPLASH
SCREEN

LAMP MODE

ON

BLUE

OFF

OFF

STANDARD

OFF

IMAGE
REVERSE

XGA60

01_ENG.fm Page 16 Friday, May 26, 2006 4:19 PM

This manual is related to the following products: