Magma A10-918 - Manual (Page 7)

6a
USING GRILL WITH ON-BOARD LPG (PROPANE) SYSTEMS
Propane (LPG)
Gas Regulator
A10-225 LPG (Propane)
10' Gas Grill Connection Kit
To other LPG
appliance
or use cap
Shut off
valve
Cylinder Valve
Gauge
Type 3
Valve
Solenoid
Gourmet
Gas Grill
Typical Marine &
R.V. Application
Align valve stem key
to valve chamber
lock detent and rotate
Gourmet
Gas Grill
Gourmet
Gas Grill
Type 3
Valve
• Magma On-Board LPG (Propane) Valves &
Hose Kits allow Magma Grills to be installed
within a boats existing on-board, pre-regulated
low pressure LPG (Propane) system.
• Use only Magma Type 3 Low Pressure
LPG (Propane) Valves. See our Valve
Application Guide at www.
MagmaProducts.com for correct valve.
• In North America use Magma A10-225
LPG 10' Gas Grill Connection Kit in
conjunction with Type 3 Valve. Outside
North America check your local dealer for
proper hose and fittings.
• A primary shutoff valve (supplied with
Gas Grill Connection Kit) must be used
with this control valve at point of connection
into your system. This allows shut off of gas
supply to hose leading to grill.
IMPORTANT!!
• DO NOT CONNECT A HIGH-PRESSURE SUPPLY HOSE
FROM A NON-REGULATED TANK DIRECTLY TO GRILL.
Magma's grills are designed for use with small disposable propane canisters or with pre-
regulated low-pressure propane and optional low-pressure valves. Running high-pressure
propane fuel supply lines on a boat is in violation of American Boat & Yacht Council (ABYC)
guidelines and is not considered a safe application. Additionally, impurities found in larger
refillable propane tanks may clog the small orifices in the high-pressure control valve/
regulator causing it to lose performance capabilities and eventually fail. Regulating these
tanks to 1/2 PSI and using this pre-regulated propane with the correct low-pressure valve
will insure safe, efficient performance of the grill.