Magma A10-918 User Manual

Page 5

ELECTRODE SPARK ADJUSTMENT

CAUTION: Spark can cause small shock. Do not leave fin-
gers on or near electrode wire while engaging igniter.

• Electrode wire should be approximately 1/8” from gas

exit hole in burner. Carefully adjust wire if required.

Left

side

slot

Burner screw

Right

side

slot

Electrode

Locking

Indents

Outer Shell

Liner

Liner Lip

Disconnect wire

DISASSEMBLY & RE-ASSEMBLY

• Lift radiant plate up & out of left slot (see B) and remove by sliding it out of

right slot (see C).

• Remove burner screw (see B) and remove burner. Check burner for grease

residue or spider webs that may obstruct gas flow. CAUTION: WHEN REPLAC-
ING BURNER, CUT SLOT IN BURNER MUST FACE DOWN.

• To remove liner from outer shell you must disconnect the electrode wire (see

D). First remove the two screws on valve chamber (see D) and remove the
cover plate. Gently pull wire off connector (see D). It is not necessary to
remove electrode from liner.

• Remove Lid and liner by removing hinge screws and lock nuts with 3/16”

hex key wrench (supplied) and 1/2” wrench or pliers. CAUTION: LOCK NUTS
MUST BE INSTALLED WITH LOCKING INDENT MARKS SHOWING (see E).
IMPROPER INSTALLATION WILL DAMAGE THE HINGE SCREW AND LOCK NUT.

• Lift liner out of outer shell by lifting up on liner lip on back side of liner

(see F). When replacing liner, be sure top lip of liner installs over top edge of
outer shell (start with corners of lip and work in).

• Inspect burner, remove any obstructions.
• Clean as indicated in Maintenance (page 6).
• To re-assemble, reverse the procedure.

Screws

Electrode