MTD 050 thru 062 - Manual (Page 13)

13
When sharpening the blade, follow the original
angle of grind as a guide. It is extremely important
that each cutting edge receives an equal amount of
grinding to prevent an unbalanced blade. An
unbalanced blade will cause excessive vibration
when rotating at high speeds, may cause damage
to the mower and could break, causing personal
injury.
The blade can be tested by balancing it on a round
shaft screwdriver. Remove metal from the heavy
side until it balances evenly. It is recommended that
the blade always be removed from the adapter for
the best test of balance.
Before reassembling the blade and the blade
adapter to the unit, lubricate the engine crankshaft
and the inner surface of the blade adapter with light
oil (or engine oil). Lubricating the bolt holes, bolts
and inner surface of the nuts is also recommended.
Figure 15
Install the blade adapter on the crankshaft with the
“star” away from the engine. Refer to Figure 15.
Place the blade with the side marked bottom (or
with part number) facing away from the adapter.
Align the blade bell support over the blade with the
tabs in the holes of the blade and insert the hex
bolt. Tighten the hex bolt to the torque listed in the
“Blade Mounting Torque” section below.
Blade Mounting Torque
Center Bolt: 450 in. lbs. min., 600 in. lbs. max.
To ensure safe operation of your unit, all nuts and
bolts must be checked periodically for correct
tightness.
DECK
The underside of the mower deck should be
cleaned after each use to prevent a buildup of grass
clippings, leaves, dirt or other matter. If this debris is
allowed to accumulate, it will invite rust and
corrosion, and may cause an uneven discharge of
grass clippings at the next cutting.
The deck may be cleaned by tilting the mower and
scraping clean with a suitable tool (make certain the
spark plug wire is disconnected).
ENGINE
Refer to the separate engine manual for engine
maintenance instructions.
Maintain engine oil as instructed in the separate
engine manual packed with your unit. Read and
follow instructions carefully.
Service air cleaner every 25 hours under normal
conditions. Clean every few hours under extremely
dusty conditions. Poor engine performance and
flooding usually indicates that the air cleaner should
be serviced. To service the air cleaner, refer to the
separate engine manual packed with your unit.
The spark plug should be cleaned and the gap
reset once a season. Spark plug replacement is
recommended at the start of each mowing season;
check engine manual for correct plug type and gap
specifications.
Clean the engine regularly with a cloth or brush.
Keep the cooling system (blower housing area)
clean to permit proper air circulation which is
essential to engine performance and life. Be certain
to remove all grass, dirt and combustible debris
from muffler area.
SECTION 12: OFF-SEASON STORAGE
The following steps should be taken to prepare lawn
mower for storage.
1. Clean and lubricate mower thoroughly as
described in the lubrication instructions.
2. Refer to engine manual for correct engine
storage instructions.
3. Coat mower’s cutting blade with chassis grease
to prevent rusting.
4. Store mower in a dry, clean area. Do not store
next to corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment
in a poorly ventilated or metal storage shed, care
should be taken to rust-proof the equipment. Using
a light oil or silicone, coat the equipment, especially
cables and all moving parts.
Blade
Adaptor
Blade
Hex Bolt
Blade Bell
Support