Makita 6812 - Manual (Page 9)

9
To install the bit, insert it as far as it will go through the open-
ing in the soft rubber collar (dust ring) on top. Then press
straight down on the bit tip until it is held in place.
After installing the bit, install the locator by pushing it firmly
back onto the locking sleeve.
Rubber cap
Use the rubber cap when fastening easily-marked work-
pieces.
OPERATION Fit the screw on the point of the bit and place the point of the
screw on the surface of the workpiece to be fastened. Apply
pressure to the tool and start it. Withdraw the tool as soon as
the clutch cuts in. Then release the switch trigger.
CAUTION:
• When fitting the screw onto the point of the bit, be careful
not to push in on the screw. If the screw is pushed in, the
clutch will engage and the screw will rotate suddenly.
This could damage a workpiece or cause an injury.
• Make sure that the bit is inserted straight in the screw
head, or the screw and/or bit may be damaged.
1. Rubber collar (Dust ring)
1
002659
1. Rubber cap
2. Locator
1
2
002670