Meridian America DSP33 - Manual (Page 42)

Troubleshooting
37
❍ Ensure that the receiver uses well-screened antenna cable.
❍ Relocate the receiver with respect to the DSP33.
❍ Connect the receiver and this product to different AC outlets.
❍ If the problem persists contact your dealer.
Centre not working
There may be a connection problem.
❍ Check that the channel switch is set to LEFT/CENTRE.
Configuring the DSP33 does not have
any effect
Make sure that you are configuring the DSP33 used as the
master digital loudspeaker in the system. This determines the
configuration of all digital loudspeakers in the system.
Green indicator on back panel is
flashing
This normally indicates that the DSP33 is overheating, and that it
has shut down to cool down. If the DSP33 is cold, it may
indicate a fault.
Meridian Configuration program
repeatedly fails to talk to the
loudspeaker
❍ Check that you have selected a COMMS port.
❍ Check that no other program currently running is using the
COMMS port.
❍ Check that it is connected correctly.
❍ Turn off the DSP33 for a few seconds and turn back on, then
retry.
❍ Quit from all other programs and retry.
❍ Reboot the computer and retry.
❍ Ensure you are using the serial lead supplied with the product,
or a null modem cable.
❍ If you are using a laptop try turning off the screensaver or
power management software.
Unit stays in standby – light is dim
❍ Check that it is connected correctly.
❍ Turn the system on from another Meridian product in the
system.