Meridian America DSP33 - Manual (Page 25)

Using the DSP33 Digital Loudspeaker System
20
When not playing, the digital loudspeakers should be left in the
standby state. This uses a negligible amount of electricity, but
ensures that the components of the loudspeakers operate at
maximum efficiency from the moment you start.
If you are not going to use the digital loudspeakers for several
days you should switch each unit completely off at the back
panel, and disconnect it from the AC power supply.
To select a source
● Press the appropriate source key on the remote; eg DVD.
This will bring the digital loudspeakers out of standby, and the
back-panel indicator on each speaker will be bright.
As standard, all the sources are set to select the D1 digital input
of the DSP33. To select the D2 input, see To configure the
source options, page 31.
To switch to standby
● Press Off on the remote.
The loudspeakers will switch to standby and the back panel
indicator on each speaker will dim.
Selecting a source