Metrologic Instruments MS9530 Series - Manual (Page 9)

FIXING VOYAGER RF ID NUMBERS
This section explains how to fix an Identifier number to each Voyager RF.
Basically, each Base Station can work with up to 5 VoyagerRF’s at the same
time. To enable this facility, an Identifier Number (ID) must be configured to
each Voyager RF. By reading RF Defaults, ID=1 is configured.
There cannot be more than one Voyager RF with the same ID and Serial
Number.
In the case of two Voyager RF’s trying to communicate with the base station at
the same time, the unit with the lower ID will re-try first. That means that the
lower a number ID the VoyagerRF has, the more aggressive it will be.
To change the ID, follow the steps below,
• Read desired Voyager ID:i (i=1,..,5) barcode to load the ID = i into
the Voyager RF
MS9530 Voyager RF
9
Printed: September 2002
Version: 1.1 Status: Approved