Metrologic Instruments MS9530 Series - Manual (Page 6)

CONNECTING THE BASE STATION TO THE HOST
WEDGE INTERFACE
1. Turn off the Host system
2. Connect the cable Y-XX between the keyboard and Host
3. When Power supply required (it is recommended all the times
for better RF transmissions), check that the voltage matches
the AC outlet and then connect
4. Power up the Host system
RS232 INTERFACE
1. Turn off the Host system
2. Connect the cable RS232(DB25/DB9) to the desired RS232
input port of the Host
3. When Host can’t provide power supply, check that the voltage
matches the AC outlet and then connect
4. Power up the Host system
LIGHT PEN AND OCIA INTERFACES
Technical assistance will be required depending on the HOST interface.
Now follow the matching procedures to link the Voyager RF to the Base Station
MS9530 Voyager RF Printed: September 2002
Version: 1.1 Status: Approved
6