Grizzly T10432 - Manual (Page 10)

-8-
Model T10432 (Mfg. Since 11/10)
inventory
inventory (figure 1) Qty
A. router Mounting Board 3 7 ⁄
8
" id .................. 1
— insert 2 5 ⁄
8
" id .......................................... 1
— insert 1 1 ⁄
4
" id ........................................... 1
B. Fence support ............................................ 1
c. Fence Boards ............................................. 2
D. guard ......................................................... 1
E. table ........................................................... 1
f. Fence scale tapes ..................................... 2
g. rubber Feet ............................................... 4
h. long Bottom stand Braces 27 1 ⁄
4
" ............... 2
i. long top stand Braces 22 1 ⁄
4
" .................... 2
J. short Bottom stand Braces 19 3 ⁄
4
" .............. 2
K. short top stand Braces 14 1 ⁄
2
" ................... 2
L. dust port housing ...................................... 1
M. stand legs 33" ........................................... 4
N. dust port 2 1 ⁄
2
"............................................. 1
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
O. hardware (not shown):
— hex Bolts M6-1 x 16 (table/Braces) ....... 4
— Fender Washers 6mm (table/Braces) .... 4
— Carriage Bolts M8-1.25 x 12 (stand) .... 32
— Flat Washers 8mm (stand) ................... 32
— hex nuts M8-1.25 (stand) .................... 32
— hex Bolts M8-1.25 x 25 (Fence) ............. 6
— Flat Washers 8mm (Fence) .................... 6
— star Knobs M8-1.25 (Fence) ................... 6
— t-Bolts M6-1 x 25 (guard) ...................... 2
— Flat Washers 6mm (guard) .................... 2
— tri-Knobs M6-1 (guard) .......................... 2
— phillips head screws M5-.8 x 55 ............ 2
—starting pin ............................................. 1
— hex Wrench 3mm ................................... 1
figure 1. Model t10432 inventory.
a
B
C
d
E
F g
h
i
J
K
l
M
n