Grizzly G5968/9 - Manual (Page 7)

-5 - G5968/9 Angle Grinder
MAINTENANCE
Disassembly and improper reassem-
bly of this device can result in elec-
trical shock danger. Always have this
device serviced by a qualified electri-
cal repair technician. Serious injury
will result.
Brushes
The brushes need to be checked periodi-
cally to ensure optimum performance. If
the brushes need to be replaced, simply
unscrew the plastic cap on both sides of
the grinder back by the trigger. Pull out
and inspect the brushes. Either re-install
or replace the brushes at this time.
Repair and Service
All quality tools will eventually wear from
normal use. Since the grinder is encased
in a double insulated plastic cover, leave
repair and service issues to a qualified ser-
vice technician.
Technical Data
Model: G5968 G5969
Rated Voltage: 110V 110V
Rated Frequency: 60 Hz 60 Hz
Rated Power Input: 450W 700W
No-Load Speed: 11,000 10,000
RPM RPM
Wear safety glasses when cleaning
tool with compressed air.
General
Regular periodic maintenance on your
Model G5968/9 Angle Grinder will ensure
its optimum performance. Make a habit of
inspecting your grinder each time you use
it. Check for the following conditions and
repair or replace when necessary:
• Loose fasteners.
• Worn switch.
• Worn or damaged cords and plugs.
• Any other condition that could hamper
the safe operation of this equipment.
Keeping Tool Clean
The Model G5968/9 Angle Grinder will
give you years of trouble free service if you
keep it clean and free of built-up dust or
grime. Ensure that no air passages get
blocked. If they do, blow them out with
compressed air.
Plastic parts can easily be cleaned with a
damp cloth, but never use water to clean
any electrical parts. Solvents should also
be avoided on plastic because of the pos-
sibility of damage.