GoVideo DDV9500 - Manual (Page 49)

CHAPTER 9 - HELPFUL INFORMATION 47
“My On-Screen Display has a message
that says ERROR.”
This means the VCR has had difficulty with the tape
mechanism. To reset, turn the power off and then on again.
If this does not clear the error, unplug the VCR from the
wall outlet and inspect both tape slots for foreign objects, or
for jammed or crooked tapes.
“Sometimes, I can’t Eject a tape
using my remote control.”
If there is scene information in the Scene Edit List from an
Automatic Assembly Edit, Deck 1 will not allow you to eject
the tape using the remote control. This is because if you
eject the tape, you will lose your scene programming. If
you still want to eject the tape, you can do so by using the
STOP / EJECT
key on the front panel—this will erase all
your Edit List settings—or you can clear all scenes in the
Edit List manually.
Remote Eject may not be turned on. See Remote Eject under
the VCR SETTINGS menu.
“I can’t reset the Deck 1 tape counter.”
If there is scene information in the Scene Edit List from an
Automatic Assembly Edit, you will not be able to reset the
Deck 1 tape counter. This is to prevent you from losing your
scene programming. To clear unwanted programming, eject
the tape from Deck 1 using the front panel Stop/Eject key.
“My VCR doesn’t work.”
A strong static electricity shock or other unforeseen circum-
stances may cause the control system of your Dual-Deck
VCR to lock up. To reset the control system, first unplug the
power cord from the wall outlet for 10 seconds and plug it in
again. If this doesn’t restore all operations to normal,
unplug it again for 15 minutes. You will then need to reset
the clock (if the clock is still set, you haven’t unplugged it
long enough). If these steps do not correct the problem, the
Dual-Deck VCR must be serviced by an authorized service
center.
“I can’t bring up the Edit List assembly menu.”
The VCR must have a tape in Deck 1 for the Edit List to
appear because a tape is required to do any editing. Edit
List is not available during Copy Tape.