beautypg.com

Trouble- shooting and service, Specifications – Gateway SW203 User Manual

Page 8

background image

8

F

TROUBLE-

SHOOTING AND

SERVICE

Before returning your SW103, SW203, or

SW303 for service, you can save time (and

often embarrassment) by checking for a few

problems that are most often encountered.

Power light is not lit.

No sound.

1. Is your SW103/SW203/SW303 plugged

in to a live AC wall socket?

2. Is the power cord firmly plugged into

the subwoofer amp power input connector?

(8) on page 4.

3. Is the power switch on?

4. Has the SW103/SW203/SW303 over-

heated and shut off temporarily?

5. Is the fuse OK?

No sound from either set of

speakers.

1. Are your other components turned on?

2. Is the receiver or preamp set to the

appropriate input and is that sound source

playing?

3. Do you have an unconnected tape

monitor selected?

4. Is the SW103/SW203/SW303 correctly

connected to your receiver, preamplifier or

integrated amplifier and turned on?

Sound comes from main

speakers but not subwoofer

1. Is the SW103/SW203/SW303 turned

on (power light in the green mode) and

VOLUME control turned up?

2. Check the speaker connections for

small strands of wire touching both

terminals.

3. Some digital receivers only send a

subwoofer out signal when in the movie or

digital mode. In the 2 channel (stereo

music) mode, no subwoofer out signal is

sent to the subwoofer. You may need to set

your main speakers to “small” mode in

your receiver setup to get the receiver’s

G

SPECIFICATIONS

SW103/SW203/SW303
Design
Venturi ported system
Amplifier Power
SW103: 100 watts RMS
SW203: 100 watts RMS (200 max.)
SW303: 150 watts RMS (400 max.)
Signal-to-Noise Ratio
Greater than 80 dB

Damping factor >500
Crossover
SW103: 120 Hz fixed
SW203/SW303: 40-180 Hz. (user variable),

active low-pass, 24 dB/octave
Subsonic Filter
18 dB/octave below 20 Hz.
Driver Complement
SW103: One 5

1

/

4

˝ (13.3 cm) long-throw woofer

SW203: One 6

1

/

2

˝ (16.5 cm) long-throw woofer

SW303: One 10˝ (25.4 cm) long-throw woofer
Frequency Response
SW103: 36-150 Hz.+/- 3dB
SW203: 30-125 Hz.+/- 3dB variable
SW303: 23-180 Hz.+/- 3dB variable
Output
Normalized 1 meter maximum SPL
SW103: 103 dB average from 36 Hz.-100 Hz.
SW203: 109 dB average from 34 Hz.-100 Hz.
SW303: 112 dB average from 27 Hz.-100 Hz.
Dimensions
SW103: 15

1

/

2

˝ (39.4 cm) H x 11˝ (27.9 cm) W

x 7

7

/

8

˝ (20 cm) D

SW203: 17˝ (43.2 cm) H x 13˝ (33 cm) W

x 10˝ (25.4 cm) D

SW303: 18

1

/

2

˝ (47 cm) H x 17˝ (43.2 cm) W

x 14˝ (35.6 cm) D

Shipping Weight
SW103: 20 lbs. (9 kg.)
SW203: 24 lbs. (10.9 kg.)
SW303: 41 lbs. (18.6 kg.)
Finish
Black laminate

subwoofer output to turn on. Check your

receiver’s owner’s manual for subwoofer

operation.

4. For digital receivers – make sure

the subwoofer is “ON” and the subwoofer

level is set to “0dB” or greater.

Sound comes from the

subwoofer but not your

main speakers

• confirm that the power amplifier is

turned on.

• check the RCA patch cord

• check the speaker wire connections

between the power amplifier and

main or satellite speakers.

Bass is muffled or weak

1. Check speaker wire polarity of

all connections.

2. Reposition your subwoofer. At

some points in the room, its output may

be cancelled by the geometry of the

room. Moving the SW103/SW203/SW303

can eliminate this problem.

Please refer to Item 10 in the Safety

Instructions for conditions that ALWAYS

require service by qualified personnel.

If you have tried all the above and

still cannot get the SW103, SW203, or

SW303 to operate properly, consult

Gateway

®

Customer Service and Support

at 1-800-846-2301.

Web site: www.gateway.com

©2003 Gateway

®

This manual is related to the following products: