GE 2-930SST - Manual (Page 8)

8
W
ALL
M
OUNT
I
NSTALLATION
RINGER ON/OFF
1
2
5
3
4
8
1. Plug the short telephone line cord into the
PHONE LINE jack on the back of the base
and connect the other end to a wall jack.
2. Plug the power supply cord into the 9V DC
jack on the base and plug the power
supply into an AC outlet.
3. Feed the short line cord through the notch
at the top of the wall mount bracket so that
it comes through the square opening on
the bracket. Then feed the power supply
cord through both the top and bottom
notches on the bracket.
4. Attach the wall mount bracket by putting
the tabs into the slots on the top of the unit
and then snap the tabs at the bottom of the
wall mount bracket into place.
5. Slip the mounting holes over the wall plate
posts and slide the unit down firmly into
place. (Wall plate not included.)
6. Raise the base antenna.
7. Set the TONE/PULSE switch to TONE for
touch-tone service, or PULSE for rotary
service. If you don’t know which type of
service you have, check with the phone
company.
8. Select RINGER ON or OFF (on the side of
handset). When you select OFF, the
handset doesn’t ring.
9. Place handset in the base to charge for 12 hours. The CHARGE/IN USE light
comes on indicating that the battery is charging.
If you don’t charge the battery properly (for 12 hours) when you first
set up the phone, the battery’s long-term performance will be
compromised.