GSI Outdoors PNEG-1597 - Manual (Page 23)

3. Assembly
PNEG-1597 Sweep Tractor Assembly Instructions 23
Sweep Tractor to Shield Assembly
1. Position sweep tractor against the sweep shield approximately 3' from the end wheel.
2. Use the bracket on the sweep tractor to mark the location where the holes need to be drilled into
the sweep shield. You may need to adjust the bolts on the sweep tractor bracket to match the same
height and angle on the sweep shield.
3. After marking the hole location, drill six (6) 7/16" holes and then attach the sweep tractor to shield
using six (6) 3/8" x 1" hex head cap screws, six (6) flat washers, and six (6) 3/8" nylon lock nuts.
4. Install electric wiring for motor and controls.
Figure 3M Shield to Tractor Assembly
All electrical wiring shall be installed by a qualified electrician and must meet
the standards set by the National Electric Code and all local and state codes.
Adjustment bolts for adjusting the angle and
height of the bracket (3/8" x 1" HHCS with
flat washer’s nylon lock nut).
Sweep shield