GSI Outdoors PNEG-1597 - Manual (Page 12)

12 PNEG-1597 Sweep Tractor Assembly Instructions
3. Assembly
Sweep Tractor Assembly
1. Place the tractor frame on plain flat ground and remove the bolts from the tractor frame.
2. Bolt the pillow block bearing to the bearing mount bracket using two (2) 1/2"-13 x 2" hex head
cap screws, two (2) flat washers, and two (2) 1/2"-13 serrated flanged nuts.
3. Bolt the bearing mount bracket to the tractor frame using two (2) 1/2"-13 x 1-1/4" flanged bolts
and two (2) 1/2"-13 serrated flanged nuts on either side (L.H. and R.H.) of the tractor frame.
NOTE: Lock collar flange must be to inside of frame.
Figure 3A
NOTE: Left Hand and Right Hand is determined
from the BACK of the tractor frame throughout
the manual.
Tractor frame
1/2"-13 Serrated
flanged nut
Bearing mount bracket
Pillow block bearing
1/2" Flat washer
1/2"-13 x 2" Hex
head cap screws
1/2"-13 x 1-1/4"
Flanged bolts
Right Hand
Front
Left
Hand
Back