GIGABYTE GN-WPKG User Manual

Page 17

3-1-2-2. 802.1x Settings - CA Server Tab

CA Server is used when TLS, TTLS or PEAP is in use. When Use certificate chain is
checked, the Client can verify if such server is reliable and then transmit Client Certificate
after the verification is confirmed.

Figure 3-8. CA Server Setting

To verify the CA server:

Confirm if the Server Certificate is issued by assigned certificate issuer. If

“Allow Intermediate Authentication” is checked, the server certificate can be issued
by one intermediate certificate issuer.

Check the server name of server certificate is the same as the name entered

by the user or belongs to the same domain.

Use certificate chain: If “Use certificate chain” is checked, it indicates that Client will

confirm whether CA server is reliable. (Default: OFF)

Certificate issuer: CA of a server certificate can be selected from certificate issuers on

the drop-down list. (Default: ANY)

Allow intermediate Certificates: When this option is checked, the certificate issuer can

be an issuer recognized by a specific certificate issuer. On the other hand, the
server certificate must be issued by a certificate issuer selected by the user.

Server name: This value can be a server name or the name of a domain where the server

is located.

Server name must match exactly: If this option is selected, the server name of server

certificate must be the same as “Server Name” or as the name of domain where the
server is located.

Domain name must end in specified name: If this option is selected, the certificate

issuer must be the domain or secondary domain entered in “Server Name”.