Grizzly G1013 - Manual (Page 18)

-16- G1013 Combination Sander
Once you have turned off the switch and discon-
nected the sander from its power source:
1. Remove the Sanding Disc Table.
2. Peel off the old Sanding Disc. Remove the
backing from the new Disc, center it and
press it firmly into place.
3. It may become necessary to remove the
Aluminum Disc from the Motor Shaft
because the Sanding Disc cannot be peeled
off or the Aluminum Disc requires cleaning.
Do not use petroleum-based solvents to
clean the surface of the aluminum disc. This
adversely affects adhesion.
Once you have turned off the switch and discon-
nected the sander from its power source:
1. Loosen the two wing nuts under the sanding
disc table.
See Figure 19.
2. Tilt the table to the desired position.
3. Tighten the wing nuts.
Disc Table Tilt
Figure 19. Disc table in tilted position.
Disc Replacement