Garland CG-60F - Manual (Page 7)

Part # 4520498 (11/24/08) Page 7
OPERATION INSTRUCTIONS
Lighting Instructions
1. First, make certain that the main power switch is set to
“OFF”
2 . Connect an electrical power cord to 120 volt supply .
3 . Turn the gas shut off valve to the “OPEN” position (valve
handle in line with piping) .
4 . Turn the main power switch to “ON”, power switch green
indicator should illuminate . Wait until gas pilot, green
indicator illuminates followed by the main burner amber
light indicator .
NOTE: Should pilot ignition fail after a few minutes turn the
main power switch to “OFF” .
Wait 5 minutes, then turn the main power switch back to “ON”.
5 . When the green indicators for their respective zones
are illuminated, set the thermostats to the desired
temperature settings .
6 . The amber burner indicators cycle with the thermostat
operation .
Note: During an electrical power interruption, turn power
switch to the “OFF” position . This unit cannot be made to
operate without electrical power .
Shut Down Instructions
1 . Turn main power switch to “OFF” (thermostat dial settings
may be left at their set point if preferred) at the end of
daily operations .
2 . For extended shut down, turn main power switch to
“OFF”, close the manual gas shut off valve and unplug the
electrical cord set .
NOTE: Do not waste gas or abuse equipment by leaving
thermostats at a high temperature setting, if not required .
During idling periods, set thermostats to a low temperature
setting. For example 175°F (79°C) to 200°F ( 93°C), to keep
griddle warm . Set thermostats, as required, for periods of
heavy load .
ADJUSTMENTS
NOTE: Each griddle has been factory tested and adjusted
prior to shipment . It may be necessary to further adjust the
unit as part of a proper installation . Such adjustments are the
responsibility of the installer . Adjustments are not considered
to be defects in material and workmanship, and they are not
covered under the original equipment warranty .
Thermostat Temperature Verification
1 . Set each thermostat dial to the same temperature .
Unless the grill temperature is being verified for a specific
function, use 360°F for the temperature setting .
Preheat the grill for 30 minutes before proceeding .
NOTE: Each minor line on the thermostat scale is 5 degrees F .
Use care when making temperature adjustments.