GarrettCom TB14H - Manual (Page 41)

TB14 and TB14H 10Mb Media Converters Installation and User Guide
32
www GarrettCom com . .
plug into the RJ-45 connector of the Magnum Media Converter.
2. Connect the other end of the cable to the corresponding device.
Use the LINK LED to ensure proper connectivity by noting that the LED will be
illuminated when the units are powered and proper connections established. If the LINK
LED is not illuminated, change the setting of the up-link switch (See Section 4.6 for up-
link switch information.) If this does not help, ensure that the cable is connected
properly at both ends and is not defective.
3.6.2 Connecting ThinNet (10BASE2)
Note: connect TP media before connecting BNC media if power is on in the
Media Converter unit. See Section 3.6 Connecting Media above.
Connect the ThinNet coax cable to the BNC connector on the TB14s Media