Grizzly G5347 - Manual

Specifications
Drive Size ......................................................... 1 /
2
"
Bolt Size Capacity ........................................... 9 /
16
"
No-Load Speed ................................... 7000 RPM
Maximum Torque .................................... 400 ft/lb
Air Inlet Size ............................................
1 /
4
" NPT
Air Consumption ..................................... 4.5 CFM
Operating Pressure ................................... 90 PSI
Weight ..........................................................6 lbs.
Operation
Attach any 1 ⁄
2
" drive socket onto your air impact
wrench. To change the rotational direction, push
the air valve knob. To adjust the torque setting,
turn the air valve knob from 0 to 5, 5 being the
highest setting (
Figure 1). Connect the impact
wrench to an air line regulated at 90 PSI.
MODEL G5347
1 ⁄
2
" EXTREME DUTY
IMPACT WRENCH
INSTRUCTION SHEET
Figure 1. Model G5347
COPyRIGhT © MAy, 2008 By GRIzzLy INDuSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY bE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROvAL OF GRIzzLY INDUSTRIAL, INC.
#JM10778 PRINTeD IN TAIWAN
Air Supply
The impact wrench MuST be regularly lubricated.
Place 3-4 drops of air tool oil directly into the
air fitting before each use. For best results, we
recommend using an in-line filter, lubricator, and
regulator, as shown in
Figure 2.
INJURY HAzARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EYE/EAR INJURY HAzARD!
Wear safety glasses and
hearing protection when
using this tool!
DO NOT EXCEED 120 PSI!
Exceeding this PSI may
result in injury/tool
damage.
SHATTERING HAzARD!
Use sockets rated for
impact wrench use only.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2 . Installing your tool.
Air Valve
Knob