Garmin 190-00888-10 - Manual (Page 3)

Thru-Hull Intelliducer Installation Instructions
Thru-Hull Intelliducer Installation Instructions
To obtain the best possible performance, install your Thru-Hull Intelliducer according to the
following instructions. If you experience difficulty during the installation, contact Garmin
Product Support, or seek the advice of a professional installer.
The Intelliducer is designed for metal and fiberglass boats. Do not install this Intelliducer in a
wood-hull boat.
This Thru-Hull Intelliducer provides depth information either to a NMEA 0183-compatible
device, or to your existing NMEA 2000 ® network, depending on the model. For more
information about NMEA 2000, visit www.garmin.com .
WARNING: See the Important Safety and Product Information guide in the product box for
product warnings and other important information.
Product Registration
Help us better support you by completing our online registration today! Connect to our Web site
at http://my.garmin.com . Keep the original sales receipt, or a photocopy, in a safe place.
For future reference, write the serial number assigned to your Intelliducer in the space provided.
The serial number is located on a sticker on the top portion of the Intelliducer.
Serial number
Contact Garmin
Contact Garmin if you have any questions while installing or using your Intelliducer. In the
USA contact Garmin Product Support by phone: (913) 397-8200 or (800) 800-1020, or go to
www.garmin.com/support/ .
In Europe, contact Garmin (Europe) Ltd. at +44 (0) 870.8501241 (outside the UK) or 0808
2380000 (within the UK).
Packing List and Tools Needed
Before installing your Intelliducer, confirm that your package includes the following items. If
any parts are missing, contact your Garmin dealer immediately.
Standard Package
Thru-Hull Intelliducer – top and bottom
portions
Gasket and locking ring
Power/data cable, or NMEA 2000 cable
NMEA 2000 T-connector
Tools Needed (not included)
Angle finder OR digital level
Safety goggles and dust mask
Drill and drill bits
Hole saws
Sandpaper
•
•
•
•
•
•
•
•
•
Mild detergent OR weak solvent (such as
isopropyl alcohol)
Marine sealant (suitable for below-
waterline use) (3M - Fast Cure 5200 or
Boat Life - Life Seal recommended)
Cable ties
Water-based antifouling paint (mandatory
for salt-water installations)
File (metal hull installations)
Fiberglass cloth and resin OR 2 in.
(51 mm) cylinder, wax, tape, and casting
epoxy (cored fiberglass hull installations)
•
•
•
•
•
•